Crusher for building materials Crusher for industry and agriculture The main working part of the crusher with a unique hammer crusher is a rotor with a hammer . A high-speed rotating hammer impacts the material block. The hammer is suspended on the hammer shaft . When the rotor is stationary, the hammer sags due to gravity. When the rotor rotates, the hammer acts like a radial centrifugal force and extends radially around it. The block that enters the machine is first struck by a hammer and broken .
The pieces of material that are broken or impacted by a hammer are then impacted or impacted against each other at a higher speed and broken. The hammer crusher has a purlin at the bottom, and the material smaller than the quilting leaks, and the material larger than the quilting stays on the purlin and is impacted and grinded by a hammer until it is broken to be smaller than the quilting and leaks.
The hammer crusher has a high speed, a large crushing ratio, and a lot of dust . The vibration amplitude of the machine after driving is required to be no more than o.2mm . Hammer crusher production decreases with increasing hammer wear, as the impact of the hammer is lessened. After the hammer is worn to a certain degree, it can be used by turning it over. When both sides of the hammer have worn to the limit, the hammer is replaced. When replacing and turning the hammer head, the hammer shaft must be pulled out and the hammer head removed before it can be performed. When replacing the hammerhead, pay attention to the weight balance of the hammerhead to ensure that the crusher runs smoothly and reduces vibration.
 
Main push magnetic separator: Dry magnetic separator, Hesha magnetic separator, grain magnetic separator, wet magnetic separator, permanent magnetic drum magnetic separator ...
The main push jig: am30 jig, 6109 jig, moving sieve jig, sawtooth jig ...
Yang
Abs Pipe Cap,Abs Fittings Cap,Abs Fittings Socket Cap,Socket Cap For Plumbers
SUPERY ABS PIPE FITTING CO.,LTD , https://www.dbrfittings.com