Flexible throttle valve works diagram, relying on stem flexible rubber tube clamping and throttling effect, you can also use the gas pressure instead of valve stem compression hose. Flexible throttle valve structure is simple, lower pressure, high reliability. Not sensitive to pollution, the working pressure range is usually 0.3-0.63MPa. Pneumatic flow control valve pneumatic actuator for speed control than the use of hydraulic flow control valve speed control difficult because of the gas compression. Therefore, the use of pneumatic flow control valve speed should pay attention to the following points, in order to prevent the occurrence of crawling: (1) the pipeline can not have leakage; (2) cylinder, piston lubrication state better; (3) flow control valve should be as Installed in the cylinder or gas motor near; (4) as far as possible the use of throttling speed control mode; (5) the applied load should be stable. If the external load changes greatly, hydraulic or mechanical devices (such as gas-liquid linkage) should be used to compensate for the speed changes caused by load changes.
custom MIM powder metal metallurgy parts,Injection molding powder metalluray MIM small metal lock parts,etc.
Mim Parts,Shaft Sleeve,Metal Injection Mim Part,Stainless Steel Mim Parts
NINGBO DAIKE INTELLIGENT TECHNOLOGY CO.,LTD , https://www.daker-hardware.com