Urban afforestation plays an important role in improving the urban environment. After planting these green plants in the spring, we must devote a certain amount of manpower and material resources to deal with them. In particular, we must regularly flush the green plants and rinse the dust off. This water can also be left in the soil, which can play a role in impounding irrigation. The Harrow Flushing Car is the preferred equipment for flushing green plants. As a professional tool truck for flushing green plants, the following issues should be noted when using it.

使用绿篱冲洗车时应该注意哪些问题1.jpg

First, when using, pay attention to whether the pipelines and equipment are in good condition. When the hedge hedge flusher is working, it uses pipelines and high-pressure water jets to perform operations. During the work process, it is necessary to pay attention to whether the water pipeline is worn or not. If there is wear, it will affect the overall operation and cause waste of water. Normally, the pipes we use for connecting are plastic pipes of about 5mm. The overall performance of this pipe is good, but it will be aging if used for a long time. New connection pipes should be replaced regularly, and the use of high-pressure water jet guns should be well controlled. Force, if it is always under the maximum pressure, will cause greater wear, which is not conducive to prolonging the service life.

Second, pay attention to whether the power provided by the vehicle is sufficient. The power of hedgerow washing vehicles is mainly provided by the on-board power system. In the process of work, only pressure and spraying need power support, and the overall energy consumption is small. The on-board power system ensures sufficient energy, so that it can continue to provide power for flushing equipment and ensure that hedge flushing is performed normally. It is recommended that enough diesel or gasoline be prepared according to the type of engine during operation. If there is insufficient power during the high-load operation, it is necessary to add energy in time. This can ensure the normal operation of the flushing vehicle.

Third, pay attention to adjusting the position and angle of parking of the vehicle when using it. If a green plant with a large area needs to be washed during a hedgerow washing operation, the location of the parking should be considered. The location near the work place should be selected. The place where the vehicle is parked should facilitate the flushing work. If it is a small-area operation, as long as it is guaranteed to stop within the effective length of the water pipeline, if it is a large-area operation, the position of the docking can be adjusted according to the progress of the work.


Electrical Infrared Heater

Advantages

Stable

Super long life, over 100,000 hours working!

Economic
Over 98% electric conversion efficiency, can save up to 70% electricity than traditional heaters!
Ecological
No any harmful rays but only good far infrared rays for human! No any harmful gas comes out.
Silent
No any noise when working, it won`t affect your sleep.
Comfortable
It will not make the room air dry which is uncomfortable!
Fast
Instantly warm. You will feel warm within just one minute in front of the heater. the front surface of the heater can rise to 90 degree C within 5 minutes!
Modern
Decorate your rooms, all panels can be printed with favorite image and you can hang it in the living room, bedroom etc. warm your home in a modern way!
Safe
There are five over heat protection in the infrared Panel Heater, the electricity will be cut off once the panel temperature rise over 105 degree C!

Electrical Infrared Heater,Infrared Electric Radiant Panel,Electric Infrared Heater,Electric Infrared Radiant Heater

Shandong Dexiang Electrical Technology Co.,Ltd , https://www.infraredroomheater.com