In our wireless video surveillance, after the wireless bridge is installed, the next step is to enter the page to connect the front-end bridge for communication. Only the bridge at the front end can communicate normally and the signal can be transmitted normally. However, what should we do if the backend bridge is not connected to the front end (the status display is not connected)? Here's a brief introduction:
1. Try to use Scan Wireless Network again to connect;
2. Confirm that the wireless bridge wireless mode (11b/g/n) is set correctly;
3. Whether the encryption mode and key between the front-end bridge and the back-end match;
4. The wireless signal strength of the peer bridge is too weak. It is recommended that the value be greater than -75 dBm.
1. Try to use Scan Wireless Network again to connect;
2. Confirm that the wireless bridge wireless mode (11b/g/n) is set correctly;
3. Whether the encryption mode and key between the front-end bridge and the back-end match;
4. The wireless signal strength of the peer bridge is too weak. It is recommended that the value be greater than -75 dBm.
Yarn Rewinding Machine,Bobbin Winding Machine,Fiberglass Winding Machine,Dye Package Winding Machine
JIEPAI MACHINERY , https://www.jyjiepai.com