Distance and distance wireless monitoring system

In some projects, different areas often have different distance ranges. The wireless bridge configured at this time is different. Here's an example to illustrate.

In one of the customer's projects, both the mining area and the office area are monitored. Among them, the monitoring center is in the office area. The mining area is within 3 kilometers from the monitoring center, and the location of the office area itself is very close, probably a few hundred meters or even a few tens of meters away.

First, the scene

It is planned to install 6 network HD cameras in the mining area. Signals need to be transmitted to a monitoring center 2 kilometers away. There is no shelter in the middle and digital microwaves can be used. The office area is planned to install about 10 network high-definition cameras, within 500 meters from the monitoring room.

Second, the solution

Six LA-5830F wireless bridges are shared by the mine to transmit the camera signals. The monitoring center uses two LA-5830F wireless bridges to receive signals from the six front-end wireless bridges, using a three-in-1 network.

10 LA-5312A wireless bridges are used in the office area to transmit signals. The monitoring center uses 2 LA-5312A wireless bridges to receive the signals from the 10 wireless bridges. It uses a 5-in-1 network. .

Third, the schematic diagram is as follows:

As shown in the figure, after the monitoring center receives the signal, it centrally enters the NVR storage through the switch, and then displays it on the wall. In this way, 16 simultaneous video signals are transmitted to the monitoring center in real time. The combination of far and near, equipped with two kinds of wireless bridges, just achieved the monitoring purpose.

Lean’s equipment is available in various distances. If there is a large deviation in the distance range in one occasion, different wireless bridges can be selected. Specific can be configured and designed by your technical staff for you.