Guidance: Laser marking machine worktable XY axis is not accurate, it will cause great errors on the processed products. If the problem can not be resolved in time may affect the delivery time of the product, the following brief introduction of the laser marking machine table XY axis troubleshooting methods.
The XY axis of the laser marking machine worktable is not accurate and will cause great errors in the processed products. If the problem can not be resolved in time may affect the delivery time of the product, the following brief introduction of the laser marking machine table XY axis troubleshooting methods.
There are several reasons and troubleshooting methods for the table XY axis is not accurate.
1, the whole machine optical screw loose, need to tighten the screws.
2. The glass on the workbench is set with the requirements of the customer. It can be replaced with iron plate or plexiglass plate, and the balance of the glass can be adjusted below.
3. The electronic ruler can be installed on the right side and the upper and lower corners of the worktable. The electronic ruler can be installed to facilitate the needs of customers.
4. The screw hole on the workbench can be used for positioning by the customer and is negated by the product.
5, XY axis jitter walk, need to check the motor, driver, signal line, drive power is faulty, replace if there is
6, in addition to the above, the XY axis is still not allowed, it may be a motherboard failure.
China leading manufacturers and suppliers of Foaming Soap Dispenser,Foam Dispenser Pump, and we are specialize in Foam Soap Dispenser Pump,Modern Foaming Soap Dispenser, etc.WIth a pump that produces 1.6cc foam output, you only need 1 pump for any application from hand washing to detergent cleaning. Save time and effort with a quality pump that dispenses the perfect amount of quality foam.
Foaming Soap Dispenser,Foam Dispenser Pump,Foam Soap Dispenser Pump,Modern Foaming Soap Dispenser
NINGBO SUNWINJER DAILY PRODUCTS CO.,LTD , https://www.nblux-pack.com