China's first tubular membrane production base, Wuhan Xin Green Industrial Park, was completed in Wuhan Economic and Technological Development Zone over the weekend and will be ready for production within the year to break the technology and market monopoly of developed countries.
According to Wang Jialian, secretary general of the Water Pollution Control Committee of the China Environmental Protection Industry Association, there are currently two major types of membrane products, namely, hollow fiber membranes and tubular composite membranes, or tube membranes. The former has been widely used in production, while the latter only has two developed countries in Germany and the United States to master the production technology. The products are in short supply in the market and the prices are high. Hundreds of engineering practices have proved that tubular membranes have a high degree of practicality, especially in areas such as difficult waste water, grease, and chemical separation.
The tubular membrane technology of Wuhan Xin Green Environmental Protection Industrial Park was developed in cooperation with the Lanzhou Membrane Division and the Wuhan Institute of Membrane Technology Application in 1986. After more than 20 years of continuous improvement, it has been applied to many areas such as domestic and industrial wastewater treatment, clean drinking water production, high-quality beverage production, oilfield reinjection water treatment, coal coking wastewater treatment, seawater desalination, etc., and achieved good results. . Wuhan Xin Gelin tubular membrane has the characteristics of high mechanical strength, strong pressure resistance, solid and durable, long service mission, strong ability of decontamination and sterilization, and low energy consumption, which fills the domestic gap.

PT100 Temperature Control

SKYELEC Heater Rod Thermostats are suitable for use with Single Phase to control heating in electroplating baths.They are equipped with a 1.6 metre supply cord and standard red cap terminal casing.

The temperature control probe is suitable for automatic control of a pre-set value in the process media and are suitable for heaters up to 2.3 kw single phase. For higher loads, or three phase heaters an additional contactor should be used.

The probes construction makes it ideally suited for etch, pickle and plating solutions. Its robust construction and chemical resistance ensures a long service life. To set the rod thermostat, unscrew the red cover which provides access to the temperature setting control knob. Turn until the desired temperature is opposite the arrow.

Suitable for use with single phase to control heating of electroplating baths and similar solutions.
Comes complete with heavy duty terminal box and adjustable mounting blocks ready for connection.
Available in: Stainless steel, Titanium, Mild Steel or PTFE.
Alternative lengths are available to order.
The units incorporate an integral 25 amp rated thermostat unit housed with a chemically resistant, PVC coated steel terminal box, complete with quick fix brackets.
The thermostat opens on a rising temperature. Range: 25°C to 100°C. They are suitable for up to 6 kw heaters on a single phase supply. For higher loads or a three phase supply an additional contactor should be used.
The control knob is situated outside the PVC coated terminal box.

PT100 Temperature Control, Heater Rod Thermostats, Electroplating Temperature Control

Guangzhou Quanxu Technology Co Ltd , https://www.skysilmattingagent.com