How to use the sprinkler (Dongfeng or Liberation)
Read the instruction manual carefully before using the sprinkler (Dongfeng or Liberation). Operating strictly according to the requirements of use is an important guarantee for using a sprinkler.
1. Requirements for Water Sources When the sprinklers (Dongfeng or Liberation) use river ditch and pond as water source, pay attention to that all the ends of the suction pipe are not submerged in water. In order to avoid inhaling stones or more sand and drift debris, the suction pipe end is generally provided with a filtering device, and it is strictly prohibited to remove the filtering device during the water absorption. If the water source is shallow, it is necessary to dig up the water absorption area in advance so as to ensure that it does not contain impurities and air. The water pump requirements for different sprinklers are different. The clean water pump requires no impurities in the water. The turbid water pump requires no stones and excessive sediment in the water.
2. Before adding water to a centrifugal water pump, a certain amount of water must be added to the water pump. After the water is added, the water inlet must be closed. When the self-priming pump is used for the first time, it is necessary to add water, and it is unnecessary to add water afterwards.
3. The water inlet pipe must be vacuumed when the water inlet pipe system must maintain a certain degree of vacuum in order to suck water into the tank. Inlet pipe system must be sealed reliably, the hose can not be damaged, the pipe can not have cracks, otherwise it will have a phenomenon of air leakage, it will result in the case of not drinking water.
4. Parking stalls Sprinklers must be parked either before or after watering.
5. Winter watering Before the advent of winter, the water in the pumps and pipes should be vented to prevent freezing. The northern part of the country is generally no longer under construction during the severe winter. Therefore, after the construction is completed, the water in the pump and the water pipe will be drained immediately to prevent future problems.
6. Sprinkler Precautions The sprinkler front nozzle is located at a low position, close to the ground, the spray pressure is greater, and can be used for flushing the road surface; the rear nozzle position is relatively high (the sprinkler rear nozzle is generally installed one on each side), and the sprinkling surface is wide, and can be used for When spraying water on highway construction, the front nozzle should be closed when the rear nozzle is used, and the width of the water can be adjusted as needed when the adjustable nozzle is used for watering. The wider the sprinkler width, the less the amount of intermediate overlap and the more uniform the sprinkler density.
7. Lubrication and fastening In the course of use, lubrication points of the drive assembly should be regularly lubricated, and the joints should be tightened frequently to ensure normal use.
8. Periodically, the sewage tank is equipped with a sewage pipe. The entrance of the pipe is the lowest point of the tank. After use for a period of time, the discharge pipe switch shall be opened periodically to remove the accumulated debris in the tank until the water becomes clear.
Modern false twist texturing (DTY) machines are equipped with up to four nip roller feeds per texturing position. Nip rollers have a major impact on the drawing process and therefore exert a direct influence on the quality of the textured yarn. Our products ensure a significant reduction in power consumption while maximizing productivity.
Stop twister is used in the false twisting process of synthetic fibers and is intended to prevent twisting. Therefore, it is also called a non-twist wheel. There are two types: metal with hard chrome plating and ceramic.
For PU disc ,we are available in a variety of thicknesses and diameters, the product offers the most suitable dimensions, adheres to tight manufacturing tolerances and ensures strict quality control for the best results for specific yarn ranges and processes.
rotating parts,plastic texturing chuck,draw textured yarn machinery,barmag dty parts
Yixing Aurora Ceramic Technology Co., Ltd. , https://www.auroracera.com