Zhengzhou Junda Machinery Equipment Co., Ltd. specializes in producing gas furnaces. The characteristics of our company's gas generators are as follows: 1. The furnace uses full water jackets, high steam production, stable pressure, and favorable gasification. 2. There is sufficient room for the gas stove to use its own steam, and a total of 50-60 people can take bath water. 3. The cooling effect inside the furnace is good, and the inner jacket of the water jacket is not deformed. 4. The furnace main lining is made of 16mm boiler steel plate. The outer lining is made of 12mm ordinary steel plate. Compared with other manufacturers, it is resistant to oxidation, corrosion, and high temperature, and improves the service life of the furnace. 5. The coal gasifier is equipped with adjustable coal separator baffle and cone type coal separator device. The coal is distributed evenly. The fuel thickness of the furnace section is basically the same, thereby increasing the gasification efficiency of the coal and preventing the occurrence of partial fire. . 6. This furnace adopts a five-story tower-shaped pentagonal furnace, and the material is made of cast steel. The design of the furnace is reasonable, the gasifying agent can be distributed evenly, and the slag can be evenly distributed during operation. The material layer distribution in the furnace is relatively stable and can be in excellent production. Gas state, and reduce the carbon content of slag. 7. Part of the ash tray adopts the transmission mechanism of the worm and worm wheel. 35# cast steel and 45# steel are selected to enhance the tensile and compressive strength of the transmission part to ensure the stability and durability of the host during normal operation. 8. Through the economic comparison of the application of coal producer gas to heating furnaces and heat treatment furnaces, from the viewpoint of energy conservation, under the normal operation of normal production, the energy consumption ratio of two kinds of fuel stoves is coal stove: gas generation Furnace = 1:0.95, that is, the use of producer gas can save energy by 5% compared with direct coal burning. 9. The use of gas furnace gas facilitates the use of small energy burners, which facilitates the adjustment of the kiln temperature through the arrangement of the burners, thereby increasing the primary product rate of the product. Traditional coal combustion methods can only heat products that do not require fuel. For example, heating products that are relatively clean must be heated by a muffle. This will undoubtedly greatly reduce the thermal efficiency of the fuel. 10. With the isolation water seal cyclone dust collector, during the power outage shutdown, the closed height of the water can be increased, and the gas between the gas furnace and the thermal furnace can be cut off to ensure that no pressure is generated and the occurrence of a temper explosion event is eliminated. 11. The company's Daipei each uses the gasifier's operator training to ensure that users can consult the gas furnace after consulting the gas furnace.

Pullout Sink Mixer

Pull Out Mixer Tap,Pull Out Sink Mixer,Single Lever Sink Mixer,Pull Out Kitchen Mixer Tap

Kaiping City Yibiao Sanitary Ware Co., Ltd. , https://www.faucetsaoli.com