If the wet cloth does not clean the dirt, try a regular detergent. If the above two methods are tried, you still cannot wipe off the dirt before you choose to clean it with water. Second, when the parts that are not wetted with water are wrapped before cleaning, the dirt is removed with a brush, water, and detergent. If you run into dirt that is difficult to remove completely, you need to use an engine-specific cleaner. It is best to choose a foam cleaner because the foam stays on the dirt surface for a long time and can break down and float off the surface. However, the chemical action of such cleaners is usually quite strong, so it should be washed with water for at least 10 minutes before it is clean. However, the following points need attention:

1. First remove dirt such as dirt or dust that can be removed with water. Always cover the parts before spraying.

2. Engine-specific cleaners should not be used for baking paint.

3. The most powerful dirt can be treated with a foam engine-specific cleaner.

4. Aluminized tank covers and exhaust pipes should be cleaned with a special cleaning agent.

5. Do not use powerful detergents first and try household detergents.

6. The dirt that solidifies due to high temperatures is the unique dirt of the engine room, and the use of special cleaning agents will be effective.

Anti-wear Ring

Installation and precautions of track connecting rod oil seal
The installation steps for the track link oil seal are as follows:
1. Cleaning: Clean the connecting parts to ensure that the surface is flat, clean, and free of grease and dirt.
2. Oil application: Apply a layer of lubricating oil to the connecting parts for better installation.
3. Installation: Gently push the oil seal into the connection area to ensure that the lip of the oil seal is not damaged.
4. Positioning: After positioning the oil seal, press it with your fingers to ensure it is in the correct position.
5. Inspection: Check if the oil seal is installed correctly and ensure that the lip is not damaged.
The precautions are as follows:
Before installation, check if the oil seal is damaged. If the oil seal is damaged, replace it with a new one.
Before installation, ensure that the surface of the connecting parts is flat, clean, and free of grease and dirt.
3. When installing the oil seal, gently push in to avoid damaging the lip of the oil seal.
4. After installation, check whether the oil seal is installed correctly to ensure that the lip is not damaged.
5. During use, the condition of the oil seal should be regularly checked. If any damage or wear is found, the oil seal should be replaced in a timely manner.

Wear ring for excavator,For excavator track,For excavator accessories

Safe Seal Technology Co., Ltd. , http://www.aprseal.com