Test preparation

When the new car arrives home, it will clean the fuel tank, gearbox, rear axle, etc., replace it with clean fuel, lubricating oil and cooling water, and add it as required.

check carefully

Check whether each control mechanism is flexible, and whether the fasteners on the front and rear axles are tightened or not. For loose parts, tighten according to the instructions. Check if the shift lever is in the neutral position. If it is not in the neutral position, it should be stepped on. Under the clutch pedal, the shift lever is placed in neutral; the vehicle with the dump device must check the handle of the dumper according to the requirements of the instructions, and place it in the disengaged position.

Smart start

After everything is checked, turn on the fuel switch and turn on the oil circuit. After the engine is started, it needs to run for a period of time at a low speed to increase the temperature of the water. When the water temperature is around 50° C., it can only start walking. Generally, the warm-up time is 3 to 5 minutes.

Run-in adjustment

Newly-produced agricultural vehicles must be put into operation after being worn out. The running road requires a small gradient, flat road surface, light to heavy loads, and low to high gears. Each gear must be worn and the common gears must be run in. During the running-in period, the clutch, brake, and other working devices should be consciously used for a certain period of time. At the same time pay attention to the working conditions of various parts and make necessary adjustments to the parts that need to be adjusted.

Cleaning and oil change

After the running-in is completed, all the lubricating oil must be cleaned and replaced. The oil change procedure and method is to change the engine oil first. After parking, heat the gearbox and the gear oil of the rear sedan shell, and add the appropriate amount of diesel oil to run for 2~3 minutes. After the oil is changed, it is cleaned, then the diesel used for cleaning is discharged, and finally, new oil is added in various parts.

Vertical Impact Crusher

There are two types of vertical axis impact crushers. One is the rock impact metal crusher, where the material is thrown onto the jaw plate inside the crusher shell. The other is that the crusher has a crushing chamber that forms the shell. The rock can accumulate in the shell at its natural resting angle, and the material impacts the rock layer at a great speed, causing it to undergo some degree of fragmentation. After the rock is thrown onto an inclined plane, it deflects upwards to the upper part of the crushing chamber, thus shifting downwards. Then, the rock curtain continuously ejected from the rotor and subjected to secondary crushing is called a rock impact rock crusher.

In a vertical impact crusher, the circumferential speed of the rotor can reach up to 99m/s, and materials with very small particle sizes fed into the crusher will also be effectively crushed. It does not have an impact hammer and has minimal metal wear. The particle size of the feed is generally less than 60 millimeters. It can be used to crush hard abrasive materials, selectively crush soft and hard materials, and has drying performance. It can replace rod mills through mixed metals.

Vertical Impact Crusher,Vertical Impact Ore Crusher,Vertical Shaft Impact Crusher

SiChuan TieYing Machinery Manufacturing CO.,LTD; , https://www.tieyingcrushers.com