In winter, the temperature is relatively low, diesel generator start often have some minor problems, some people often use some incorrect methods, so that the diesel engine is damaged, there are six methods for starting the diesel engine at low temperatures in winter is not desirable:
1. Heat the fuel tank with an open flame. Heating an oil tank with an open flame will not only damage the paint on the surface of the body, but also easily burn the plastic tubing, causing oil leakage. It may even explode due to the rapid expansion of gas in the tank, resulting in the destruction of the body and casualties.
Second, use an open flame baking oil pan. Bake the oil sump with an open flame will not only affect the life of the engine, but also make the engine oil deteriorate and reduce the lubrication effect.
Third, do not add cooling water at the start. If you do not add cooling water at the time of start-up and you add the cooling water after the diesel engine is started, the temperature of the tank will cause the body and cylinder head to crack due to sudden cold water.
Fourth, add oil from the intake pipe. Adding oil from the intake pipe will make the piston and piston ring coke, reducing the service life.
Fifth, take off the air filter and start fire. Taking off the air filter and starting the suction will cause the unclean air to enter the moving parts such as the cylinder and the air valve, which will aggravate the wear of these parts.
Sixth, do not preheat and use other power to force start. Diesel generator sets without preheating, but with other power forced start, the crankshaft and the bearing between the dry friction or semi-dry friction state, it is easy to cause the crankshaft to hold the tile.
Prev:How to start diesel generator at low temperature
Electronics Production Machinery
SF-580is a Automatic Lead Cutting And Bending Triode Forming Machine.Size:1500x1000x1500
1.Apply to LED/light emitting diode,Triode Forming Cutting Machine,aluminum electrolytic capacitor,metallic film capacitor,safety capacitor,quartz crystal and other upright type elements.
2. Import CAM mechanical transmission,precise stable,durable and low noise. Each part has the special hard coating with long service life.
3. The led Lead Forming Machine whole set of system is used PLC control with ultra strong stability.The operator interface is touch screen convenient and easy to lean and the data alignment is more convenient.
4. Speed control of the non-phase fine adjustment of transducer.
5. Upper clipand open clip system are rack and pinion type.The change of fixture centerline is invariant,no harm by clipping and more convenient to change the specification.(D4--(D6are shared the same fixture and(D8-(D10are shared the same fixture.
6. Molding pitch:2.0mm,2.5mm,5mm,7.50mm,10mm,15mm,20mm,25mm
7. Molding/feet cut method:odd leg,90℃bending,incurvature, excurvation and vertical angle,etc.
8. Length of feet cut:2.5mm-28mm.
9. Working pressure:4kg/Cm2
10.The special molding pattern can be customized according to the clients different requirements.
11. The equipment is anti-static.
The Bulk Resistor Radial Cutting Machine is suitable for shaping and cutting feet of various electronic components.Any details you want to know about Automatic Lead Forming Machine please contact us for further more.
Electronics Production Machinery, forming machine, cutting machine
SINGSUN ELECTRONIC SCIENCE & TECH CO.,LTD , https://www.singsunautomatics.com